A Modified Constrained Groove Pressing Process (MCGP) for Enhanced Strength and Microstructural Refinement of Deoxidized High-Phosphorus (DHP) Copper Sheets: Potential Implications for Marine Component Reliability

Deoxidized high-phosphorus (DHP) copper is widely used in marine heat-exchangers and seawater piping, where long-term structural reliability demands both high strength and a deformation-tolerant microstructure to resist damage initiation. Constrained groove pressing (CGP) is a scalable severe plastic deformation route for metallic sheets; however, the sharp trapezoidal junctions of the conventional die impose parasitic bending strains that produce sinusoidal in-plane hardness variations and anisotropic properties. This study introduces a modified CGP (MCGP) process in which the sharp crest and valley of each 45° tooth are replaced by tangent circular arcs (R1 = 1.6 mm at the crest, R2 = 4.8 mm at the valley), removing geometric discontinuities while exactly preserving the groove angle, pitch, and die envelope for drop-in compatibility with existing equipment. DHP copper sheets processed by conventional CGP and MCGP were systematically compared using optical microscopy, SEM, XRD, microhardness, tensile testing, and finite-element analysis. MCGP delivered exceptional mechanical performance: yield strength of 281.19 MPa, ultimate tensile strength of 451.94 MPa (96.4% above the as-received state and 23.8% above conventional CGP), mean hardness of 131.38 HV, and the finest apparent (instrument-uncalibrated) coherent diffraction-domain size of 22.75 nm. Finite-element modelling revealed a lower peak equivalent plastic strain with a more continuously distributed through-thickness deformation path, despite an unchanged nominal grooving strain (≈0.56). Notably, while the modified die redistributes deformation rather than amplifying the nominal strain, the measured through-thickness hardness inhomogeneity factor increased from 7.14% to 21.97% due to strain concentration in the mid-thickness region, indicating that full homogenisation requires further arc-radius optimisation. Nevertheless, the substantial gains in strength and microstructural refinement demonstrate that MCGP offers a promising processing route for producing DHP copper components with enhanced strength and refined microstructures, which may contribute to improved damage tolerance. However, it is acknowledged that direct tests on seawater corrosion, corrosion fatigue, and thermal cycling were not performed in this study; the implications for marine service life are inferred from the established literature on the benefits of grain refinement for corrosion and fatigue resistance. Future work incorporating marine environmental performance tests is recommended to validate these implications.